Practice Free H35-581_V2.0-ENU Exam Online Questions
The logical channel is located between the MAC layer and the RLC layer. Which of the following does not belong to the control channel?
- A . DCCH
- B . BCCH
- C . PCCH
- D . DTCH
Which of the following are service integrity indicators? (Multiple choice)
- A . Average throughput of uplink and downlink cells
- B . Average throughput of uplink and downlink users
- C . PRB Utilization
- D . CPU utilization
In NSA network, which of the following messages indicates that the UE has fully accessed the 5G network?
- A . SgNodeB: After Addition Complete
- B . After SgNodeB Addition Request
- C . After the UE completes the RA on the SgNodeB
- D . After RRC Connection Reconfiguration
Which of the following descriptions of uplink rate optimization parameters are correct? (Multiple choice)
- A . The larger the PUSCH IBLER threshold, the higher the MCS order
- B . The larger the DMRS overhead, the lower the uplink peak rate but the better the demodulation performance.
- C . The more PUCCH resources there are, the fewer PUSCH resources there are. PUCCH resources need to be allocated reasonably
- D . Uplink CCE resources will not affect the uplink rate
Shaping applies the principle of interference. The locations where wave crests meet are superimposed and enhanced, while the locations where wave troughs meet are superimposed and weakened.
- A . True
- B . False
After the T300 timer expires, the UE will trigger a reestablishment
- A . True
- B . False
Huawei base station’s ChMeas, MCS, and DuCell are mainly used to measure which of the following indicators?
- A . Cell traffic
- B . Mobile Performance
- C . Network Load
- D . Channel quality
In NSA networking scenario, after LTE sends the measurement control of NR cell, which of the following reasons will cause the terminal not to report B1 measurement? (Multiple choice)
- A . The SSB frequency configuration on the LTE side and the NR side is inconsistent
- B . AAU channel power is too low
- C . 5G measurement target cell is not issued
- D . Not all adjacent 5G cells are added
Which of the following are the main functions of CSI-RS? (Multiple choice)
- A . CS i Acquisition
- B . Beam Management
- C . RLMRRM measurement version
- D . Rate matching puncturing
In a scenario where the 5G cell bandwidth is 100MHz and the subcarrier spacing SCS is 30KHz, what is the minimum protection bandwidth?
- A . 845KHzB
- B . 925KHz
- C . 825KHz
- D . 860KHz