Practice Free H19-401_V1.0 Exam Online Questions
Which of the following alarms you see on the SecoManager side needs to focus on? (Multiple choice)
- A . Alarm for inconsistent configurations between the device and the controller (there are differences in the configuration data on the controller and the device, there may be multi-head management or the device has not saved the configuration and restarted)
- B . Server cluster node down alarm (a node in the controller cluster is faulty and needs to be repaired in time)
- C . Configuration backup task failure alarm ((The controller failed to back up the configuration file on the device, which may cause the device configuration to be unable to be restored after subsequent device failure)
- D . Equipment status down alarm (the equipment is offline and out of control)
Which of the following statements about Veeam secure recovery is correct?
- A . Automatically disconnect the link and move data to the isolation area to improve security.
- B . The backup storage of the production center and safe isolation area adopts secure snapshot technology to ensure that the data is read-only and cannot be modified or deleted within the specified time.
- C . SMB messages are transmitted in ciphertext to prevent data theft.
- D . Before recovery, please start the disease prevention software scan to restore the data to the production environment. Start the virtual machine in the isolation environment (virtual laboratory) and check whether the virtual machine is normal
NGFW security policy can filter for (). (Multiple choice)
- A . Source security zone or destination security zone
- B . Source port or destination port
- C . Source address/region or destination address region
- D . User
- E . Application or time period
The entire OceanStor Dorado series supports full sharing of 10 interface cards.
- A . True
- B . False
Typical triggering methods for 802.1X authentication include client-initiated triggering or AAA authentication server-initiated triggering.
- A . True
- B . False
What are the channels for help when using planning and design tools? (Multiple Choice)
- A . Help channel on the right side of the tool
- B . The interface person’s email address and interface person Welink in the upper right corner of the tool introduction page
- C . If you comment on the tool introduction page for details, you can leave a message online if you need help.
- D . No channel for help
What are the installation methods for outdoor APs and antennas? (Multiple choice)
- A . Pole installation
- B . Wall installation
- C . Bracket installation
- D . Threaded rod installation
Regarding the description of the dual-Border and WAC interconnection design of the campus distributed gateway, which is incorrect?
- A . In the Overlay interworking solution, it is recommended to run VRRP on Vbdif between the two Borders, and the VRRP virtual address serves as the gateway for wireless users;
- B . When wireless centralized forwarding is used, management IP interoperability and service VLAN interoperability are required between WAC and Border, that is, Underlay and Overlay need to be opened;
- C . When performing wireless local forwarding, only the management IP needs to be communicated between WAC and Border, that is, Underlay is connected;
- D . Supported networking: WAC dual-machine hot backup (VRRP dual-machine hot backup or dual-link hot backup), and dual-Border port sub-type networking, dual-machine VRRP hot backup is recommended; in multi-campus interconnection LAN-WAN integration scenarios, refer to the following topology
What are the advantages of OceanStor Pacific in HPDA scenarios?
- A . Lossless protocol interoperability
- B . High-density hardware
- C . Smart card
- D . Support mixed loads