Practice Free D-PDC-DY-23 Exam Online Questions
When using Policy-Based Routing, what is a valid action?
- A . Set source IP address
- B . Drop packet
- C . Set destination TCP port number
- D . Set 802.1Q VLAN ID
An administrator is implementing VLT in OS10.
How should the administrator configure the VLTi port channel?
- A . A port channel is created automatically during LLDP discovery.
- B . Create a LACP trunk with spanning tree disabled.
- C . A port channel is created automatically during VLT discovery.
- D . Create port channel 1000 and assign as peer-link.
What is the function of UFD?
- A . Detects the loss of downstream activity.
- B . Load balances upstream activity.
- C . Prevents the loss of upstream activity.
- D . Detects the loss of upstream activity.
Which command mode allows configuration of switches L2 and L3 interfaces?
- A . EXEC Mode
- B . Interface
- C . Configuration
- D . Global
What should be disabled on an interface before disabling LLDP transmit capability?
- A . LLDP-MED
- B . Loop Guard
- C . VLAN 1
- D . STP
Which of the following owns the VRRP group address to be used as the gateway for the hosts on the LAN?
- A . Primary router
- B . IP address owner
- C . Backup router
- D . VRRP router
In a VRRP configured environment without VLT, how does the backup VRRP peer respond to ARP requests?
- A . Sends an ICMP redirect message
- B . Responds to ARP requests with the MAC address of the master peer’s IP
- C . Does not respond to ARP requests
- D . Responds to ARP requests with the MAC address of the virtual IP address
Two Dell Networking OS10 switches are connected with a port channel that spans multiple ports.
What is a supported physical port configuration for this connection?
- A . Copper and optic ports can only be mixed with the same speed
- B . Optic ports can only be mixed with copper ports when faster due to higher latencies
- C . Optic and copper ports cannot be mixed in the same LAG
- D . Copper ports can only be mixed with optic ports when faster due to higher latencies
What are two advantages of network automation? (Select 2)
- A . Allows devices to be managed individually
- B . Utilizes traditional CLI approach for deployment
- C . Simplifies network deployment
- D . Manages the network as a single entity
A network administrator is troubleshooting VLT behavior where all VLT port channels are down on both VLT peers.
What type of mismatch can cause this issue?
- A . Spanning-tree mismatch at port level
- B . VLT LAG ID mismatch
- C . Spanning-tree mismatch at global level
- D . System MAC mismatch